No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Routing Policy

Configuring a Routing Policy

Pre-configuration Tasks

Each node of a routing policy can have a unique set of if-match and apply clauses.

Before configuring a routing policy, configure routing protocols.

Configuration Procedure

Before configuring the if-match and apply clauses, you must configure a routing policy. You can configure the if-match and apply clauses in any sequence based on network requirements.

Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 56103

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next