No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Prohibiting an OSPF Interface from Sending and Receiving Protocol Packets

Prohibiting an OSPF Interface from Sending and Receiving Protocol Packets

Context

To prevent devices on other networks from obtaining local OSPF routing information, and to prevent the local device from receiving the routing update information advertised by other devices on the same network, you can prohibit an OSPF interface from sending and receiving protocol packets.

After an OSPF interface is prohibited from sending and receiving OSPF packets, the interface can still advertise its direct routes, but not Hello packets. Therefore, no neighbor relationship can be set up between the device and other devices through this interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run silent-interface { all | interface-type interface-number }

    The OSPF interface is prohibited from sending and receiving OSPF packets.

    By default, an interface is allowed to send and receive OSPF packets.

    You can prohibit an interface from sending and receiving OSPF packets in different OSPF processes, but the silent-interface command is valid only for the OSPF interface in the local process.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 47014

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next