No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring FRR for IPv6 Static Routes

(Optional) Configuring FRR for IPv6 Static Routes

Pre-configuration Tasks

Before configuring FRR for IPv6 static routes, complete the following task:

  • Configure link layer parameters and IPv6 addresses for interfaces to ensure that the link layer protocol on the interfaces is Up.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6 route-static frr [ vpn-instance vpn-instance-name ]

    FRR is enabled for public network IPv6 static routes.

    NOTE:

    To implement route backup by configuring FRR for ipv6 static routes, specify different preferences for these static routes.

    Only CE5880EI, CE6850HI, CE6850U-HI, CE6851HI, CE6855HI, CE6856HI, CE6857EI, CE6860EI, CE6865EI, CE6870EI, CE6875EI, CE6880EI, CE7850EI, CE7855EI, CE8850EI, CE8860EI, CE8861EI, and CE8868EI support vpn-instance vpn-instance-name parameter.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display ipv6 routing-table verbose command to check information about the backup outbound interfaces and backup next hops of static routes in the routing table.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 50695

Downloads: 60

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next