No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Active/Standby Switchover Upon Abnormal OSPF LSA Aging

Disabling Active/Standby Switchover Upon Abnormal OSPF LSA Aging

Context

If the aging timer expires on the local device due to an abnormality, the local device incorrectly clears all Router LSAs from the remote device, which causes route flapping and service interruptions. To resolve this issue, active/standby switchover upon abnormal OSPF LSA aging is automatically enabled. Active/standby switchover is triggered to restore network connections and service traffic when the following condition is met:

(Number of incorrectly cleared Router LSAs/Total number of Router LSAs) x 100% ≥ 80% (Router LSAs are those sent by the remote device to the local device.)

To disable function of triggering an active/standby switchover upon abnormal OSPF LSA aging, run the ospf maxage-lsa auto-protect disable command.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf maxage-lsa auto-protect disable

    The active/standby switchover upon abnormal OSPF LSA aging is disabled.

    By default, active/standby switchover upon abnormal OSPF LSA aging is enabled.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45713

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next