No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic IPv6 BFD for IS-IS

Configuring Dynamic IPv6 BFD for IS-IS

Applicable Environment

If the requirement for data transmission is high and IS-IS convergence needs to be accelerated when the link status changes, you can configure dynamic BFD on IS-IS links. BFD can provide link failure detection featuring light load and high speed (at the millisecond level). With dynamic BFD, routing protocols can dynamically trigger the establishment of BFD sessions.

Dynamic BFD needs to be configured based on the actual network environment. If the time parameters are set improperly, network flapping may occur.

Pre-configuration Tasks

Before configuring dynamic IPv6 BFD for IS-IS, complete the following tasks:

Configuration Procedure

Figure 8-1 Flowchart for configuring dynamic IPv6 BFD for IS-IS

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 55399

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next