No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 IS-IS Auto FRR

Configuring IPv6 IS-IS Auto FRR

Applicable Environment

As the network keeps developing, services such as Voice over IP (VoIP) and on-line video services require high-quality real-time transmission. Nevertheless, if an IS-IS fault occurs, traffic can be switched to a new link only after the following processes: fault detection, LSP update, LSP flooding, route calculation, and FIB entry delivery. As a result, traffic is interrupted for much more than 50 ms, which cannot meet the requirement for real-time services on the network.

With IPv6 IS-IS Auto FRR, devices can rapidly switch traffic from faulty links to backup links without interrupting the traffic. This protects traffic and greatly improves the reliability of IS-IS networks.

IPv6 IS-IS Auto FRR is applicable to the services that are very sensitive to packet delay and packet loss.

Pre-configuration Tasks

Before configuring IPv6 IS-IS Auto FRR, complete the following task:

Configuring Basic IPv6 IS-IS Functions

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS process is enabled and the IS-IS view is displayed.

  3. Run ipv6 frr

    The IPv6 IS-IS FRR view is displayed.

  4. (Optional) Run frr-policy route route-policy route-policy-name

    Backup routes are filtered using a filtering policy. Only backup routes that have passed the filtering policy are added to the routing table.

  5. Run loop-free-alternate [ level-1 | level-2 | level-1-2 ]

    IPv6 IS-IS Auto FRR is enabled and the loop-free backup route is created.

    If the IS-IS level is not specified, IPv6 IS-IS Auto FRR is enabled on Level-1 and Level-2 to create the backup route.

  6. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6 [ verbose | [ level-1 | level-2 ] | ipv6-address [ prefix-length ] ] * command to check information about the primary link and backup link after IPv6 IS-IS Auto FRR is enabled.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 56192

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next