No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring IPv6 BFD for a Specified Interface

(Optional) Configuring IPv6 BFD for a Specified Interface

You can configure IPv6 BFD parameters on a specified interface. The priority of IPv6 BFD parameters on an interface is higher than that of IPv6 BFD parameters in the process.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run isis ipv6 bfd enable

    IPv6 BFD is enabled on the interface to establish IPv6 BFD sessions.

    After IPv6 BFD is globally enabled in an IS-IS process, default IPv6 BFD parameters are used for establishing IPv6 BFD sessions.

  4. (Optional) Run isis ipv6 bfd { min-rx-interval receive-interval | min-tx-interval transmit-interval | detect-multiplier multiplier-value | frr-binding } *

    IPv6 BFD parameters are configured for setting up BFD sessions.

    By default, the minimum interval at which IPv6 BFD packets are sent or received is 1000, in milliseconds; the IPv6 BFD local detection multiplier is 3.

    NOTE:

    The priority of IPv6 BFD configured on an interface is higher than that of IPv6 BFD configured for a process. That is, if BFD is also enabled on an interface, the parameters on the interface are preferentially used to establish a dynamic BFD session.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 45706

Downloads: 58

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next