No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Preference for Equal-cost OSPF Routes

Setting the Preference for Equal-cost OSPF Routes

Context

After OSPF calculates equal-cost routes, you can run the nexthop command to select the route with the highest preference from the equal-cost routes as the next hop. A smaller value of weight indicates a higher route preference. The default weight is 255. If OSPF discovers equal-cost routes and the number of equal-cost routes is less than or equal to that specified in the maximum load-balancing number command, OSPF performs load balancing among these equal-cost routes.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run nexthop ip-address weight value

    The preference is set for an equal-cost route.

    • The parameter ip-address specifies the next-hop address of the equal-cost route.
    • The parameter value specifies the weight of the next hop. The default value is 255. A smaller value of weight indicates a higher route preference.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074760

Views: 57439

Downloads: 62

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next