No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an Isolated Interface

(Optional) Configuring an Isolated Interface

Context

In data center server virtualization scenarios, multiple virtual machines (VMs) in a physical server may belong to the same VLAN and require Layer 2 isolation. The VMs connect to the same user interface on the MFF-enabled device. Services on the VMs are often isolated, so the MFF-enabled device must respond to ARP request packets. If the MFF-enabled device does not respond to ARP request packets, VMs cannot communicate at Layer 3.

MFF provides the isolated interface to address this issue. After an isolated interface is configured, the MFF-enabled device does not check interface consistency in ARP request packets sent by users. Instead, the MFF-enabled device directly responds to the ARP request packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run mac-forced-forwarding user-isolate-port

    The interface is configured as an isolated interface.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 18356

Downloads: 60

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next