No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Handshake Function for 802.1x Online Users

(Optional) Configuring the Handshake Function for 802.1x Online Users

Context

You can configure the handshake function for online users to ensure that the users are online in real time. The device sends a handshake request packet at intervals to online users who pass the authentication. If the user does not respond to the handshake packet after the maximum number of retransmission times, the device disconnects the user.

If the 802.1x client cannot exchange the handshake packet with the device, the device does not receive any handshake response packet within the handshake period. You must disable the handshake function for online users to prevent the device from incorrectly disconnecting the users.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dot1x handshake

    The handshake function is enabled for 802.1x online users.

    By default, the handshake function is disabled for 802.1x online users.

  3. (Optional) Run dot1x retry max-retry-value

    The maximum number of times an authentication request can be sent to an 802.1x user is set.

    By default, the device sends an authentication request to an 802.1x user twice.

  4. (Optional) Run dot1x timer handshake-period handshake-period

    The 802.1x timers are configured.

    The interval for sending handshake packets is set.

    By default, the interval for sending handshake packets is 60 seconds.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 18832

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next