No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling 802.1x Authentication

Enabling 802.1x Authentication

Context

You must enable 802.1x authentication before configuring it.

802.1x authentication can take effect on interfaces only after you enable 802.1x authentication both globally and on interfaces.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dot1x enable

    802.1x authentication is enabled globally.

    By default, 802.1x authentication is disabled globally.

  3. Enable 802.1x authentication on interfaces. This command can be configured in the system view or interface view. In the system view, the command can be configured on one or more interfaces; in the interface view, the command can only be configured on a specified interface.

    By default, 802.1x authentication is disabled on interfaces.

    View

    Procedure

    System view

    Run the dot1x enable interface interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command to enable 802.1x authentication on interfaces.

    Interface view
    1. Run the interface interface-type interface-number command to enter the interface view.

    2. Run the dot1x enable command to enable 802.1x authentication on the interface.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 18480

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next