No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Basic ACL6 Rule

Configuring a Basic ACL6 Rule


A basic ACL6 classifies packets by matching packet information against its rules. After a basic ACL6 is created, configure rules in the ACL6.


When the device receives a packet, it matches the packet against ACL rules one by one based on the configuration order. Once the packet matches a rule in an ACL rule group, the device stops the matching process and performs the action specified in the matching rule on the packet.


  1. Run system-view

    The system view is displayed.

  2. Run acl ipv6 { [ number ] acl6-number | name acl6-name basic }

    A basic ACL6 is created, and the basic ACL6 view is displayed.

    The parameter acl6-number specifies the number of a basic ACL6. The value ranges from 2000 to 2999.

    By default, no ACL6 is created.

  3. Run rule [ rule-id ] [ name rule-name ] { deny | permit } [ fragment | source { source-ipv6-address { prefix-length | source-wildcard } | source-ipv6-address/prefix-length | any } | time-range time-name | vpn-instance vpn-instance-name ] *

    Rules for the basic ACL6 are configured.


    When you configure a basic ACL6:

    • If all source IPv6 addresses are specified (any in Step 3), the system will not check packets' source IPv6 addresses.

    • When you specify the parameter time-range to reference a time range to the ACL6, the ACL6 does not take effect if the specified time-name does not exist.

  4. (Optional) Run rule rule-id description description

    The description of a basic ACL6 rule is configured.

    By default, no description is configured for an ACL6 rule.

    You are not allowed to configure the description for a rule that has not been created.

  5. Run commit

    The configuration is committed.

Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 29197

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next