No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Whitelist for Attack Source Tracing

Configuring a Whitelist for Attack Source Tracing

Context

Attack source tracing locates and attack sources of denial of service (DoS) attacks and takes punish actions on the attack sources. If some users do not need to be traced regardless of whether they might initiate attacks, add the users to a whitelist.

NOTE:
  • Before referencing an ACL in a whitelist, create the ACL and configure rules.

  • To specify a protocol type in the ACL referenced by the whitelist, ensure that this protocol supports the attack source tracing function. If a protocol is not supported by attack source tracing, you can run the auto-defend protocol command to configure attack source tracing to support the protocol.

  • The whitelist may fail to be applied because ACL resources are insufficient.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run cpu-defend policy policy-name

    The attack defense policy view is displayed.

  3. Run auto-defend enable

    Attack source tracing is enabled.

    By default, attack source tracing is disabled.

  4. Run auto-defend whitelist whitelist-number { acl { acl-number | ipv6 acl6-number } | interface interface-type interface-number }

    A whitelist is configured.

    By default, there is no whitelist for attack source tracing.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 23994

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next