No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPSG

Configuring IPSG

Pre-configuration Tasks

Before configuring IPSG, complete the following task:
  • Configure an IP address for the interface to ensure that the link protocol is in the Up state.

Configuration Procedure

To configure IPSG, you must configure a binding table and enable IP packet check. All other configuration tasks are optional and are not listed in sequence. You can configure them as required.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 23350

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next