No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for Keychains

Application Scenarios for Keychains

Keychain provides authentication for applications. The following application protocols support Keychain authentication: Routing Information Protocol (RIP), Intermediate System to Intermediate System (IS-IS), Open Shortest Path First (OSPF), Border Gateway Protocol (BGP), Label Distribution Protocol (LDP), and Multicast Source Discovery Protocol (MSDP). Applications use the same Keychain authentication procedures. Create a Keychain and then use the Keychain to perform an authentication.

IS-IS Using Keychain for Authentication

IS-IS is a commonly used routing protocol, and IS-IS security is needed. You can configure a fixed authentication algorithm and key to authenticate IS-IS packets. But fixed authentication algorithms and keys may be decrypted. The use of Keychain to authenticate the IS-IS packets makes IS-IS more secure.

As shown in Figure 17-7, SwitchA, SwitchB, SwitchC, SwitchD and SwitchE use IS-IS to communicate. SwitchA, SwitchB, and SwitchC belong to area 10; SwitchD and SwitchE belong to area 20. SwitchA and SwitchB are Level-1 devices; SwitchD and SwitchE are Level-2 devices; SwitchC is a Level-1-2 device. Create a Keychain on each device to authenticate the IS-IS packets. Configure area and domain authentication in the IS-IS process, and configure interface authentication on the interface as well.

Figure 17-7 IS-IS using Keychain for authentication
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 29237

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next