No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Microsegmentation

Enabling Microsegmentation

Context

You must enable microsegmentation before configuring microsegmentation.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (For the CE6857EI, CE6865EI, CE8861EI, and CE8868EI) Run system resource uft-hybrid acl { arp | mac | route }

    The system resource mode is set to UFT flexible resource mode with acl specified.

    By default, the standard system resource mode is used.

    NOTE:

    The configuration takes effect after you save the configuration and restart the device. You can restart the device immediately or after completing all the configurations.

  3. (For the CE6857EI, CE6865EI, CE8861EI, and CE8868EI) Run assign forward acl resource epg

    The UFT flexible resource mode of ACL entries is configured to allocate ACL entries to the microsegmentation service.

    By default, the system assigns ACL entries to the MQC service after the system resource mode is set to the UFT flexible resource mode of ACL entries.

    NOTE:

    The configuration takes effect after you save the configuration and restart the device. You can restart the device immediately or after completing all the configurations.

  4. Run traffic-segment enable

    Microsegmentation is enabled.

    By default, microsegmentation is disabled.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100074765

Views: 22461

Downloads: 92

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next