No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Components of the Intelligent Traffic Analysis System

Components of the Intelligent Traffic Analysis System

Components of the Intelligent Traffic Analysis System

A typical intelligent traffic analysis system consists of the traffic-analysis data exporter (TDE), traffic-analysis processor (TAP), and traffic-analysis data analyzer (TDA).

  • TDE: is a switch enabled with the intelligent traffic analysis function. The TDE is responsible for determining the service flows to be detected and sending them to the TAP.

  • TAP: is a built-in chip on the CPU of the switch. The TAP processes and analyzes the service flows sent by the TDE, and exports the analysis results to the TDA.

  • TDA: is a network traffic analysis tool that provides a graphical user interface (GUI) for users to easily obtain, view, and analyze collected data. Currently, only FabricInsight can function as the TDA.

In actual applications, the TDE and TAP are integrated on one switch. In Figure 18-1, when packets in a specified service flow are sent and received along the same path, each device through which the flow passes can obtain the bidirectional traffic of the flow. You can analyze indicators such as the packet loss rate and delay of the flow on these devices.

Figure 18-1 Components of the intelligent traffic analysis system

Working Process of the Intelligent Traffic Analysis System

Figure 18-2 Working process of the intelligent traffic analysis system

As shown in Figure 18-2, the working process of the intelligent traffic analysis system is as follows:

  1. After a service flow to be detected is configured, the TDE uses the delivered ACL rule to match the service flow. The matched service flow is sent by the forwarding chip to the TAP.
  2. The TAP processes the received flow. If the flow meets the requirements, the TAP creates a flow table for analysis. If the flow does not meet the requirements or exceeds the processing performance of the TAP, the TAP discards the packets.
  3. The TAP encapsulates the analysis result using a specified destination address, and sends the encapsulated packet to the forwarding chip for route searching and forwarding. The TDA performs further analysis and display after receiving the packet.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 28607

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next