No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Telemetry Static Subscription

Configuring Telemetry Static Subscription

Telemetry static subscription indicates that a device functioning as a client initiates a connection to a collector functioning as a server to send data collected.

Usage Scenario

The controller uses commands to configure devices that support Telemetry, subscribe to data sources, and collect data. The protocol used to send data can be gRPC.

If the connection between a device and the collection is interrupted, the device connects to the collector and sends data again. However, the data sampled when the connection is being re-established is lost.

After an active/standby switchover is performed or the system saves Telemetry service configurations and restarts, the Telemetry service reloads its configurations and continues to run. However, the data sampled during the restart or active/standby switchover is lost. This poses high pressure on devices. Therefore, Telemetry static subscription is often used for coarse-grained data collection.

Pre-configuration Tasks

Before configuring Telemetry static subscription, configure a static or dynamic routing protocol so that devices can communicate at the network layer.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 30894

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next