No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the VXLAN Flexible Flow Configuration

Verifying the VXLAN Flexible Flow Configuration


You can run commands to verify the configuration of VXLAN flexible flow statistics exporting.


  • Run the display forward enp [ slot slot-id ] command to check whether the card performs NetStream sampling in enhanced mode.


    The CE12800E configured with ED-E, EG-E, and EGA-E series cards does not support this command.

  • Run the display netstream cache vxlan inner-ip record record-name [ { inbound | outbound } | destination interface interface-type interface-number | destination ip ip-address | destination port port-number | source interface interface-type interface-number | source ip ip-address | source port port-number | protocol protocol-type | tos tos-number ] * slot slot-id [ chip chip-id ] [ verbose ] command to check VXLAN flexible flow statistics on a card.
  • Run the display netstream export vxlan inner-ip template command to check the template output information.
  • Run the display netstream statistics vxlan inner-ip slot slot-id [ chip chip-id ] command to check VXLAN flexible flow statistics on the card.
  • Run the display netstream { all | global | interface interface-type interface-number } command to check the NetStream configuration.
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 28909

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next