No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishing the Configuration Task

Establishing the Configuration Task

Usage Scenario

Based on IP FPM, iPCA can measure the performance of IP networks.

The iPCA hop-by-hop performance measurement function supported by the switch includes the continual and on-demand modes. The two modes have the following difference:
  • On-demand measurement: If you detect that network performance degrades or you want to precisely locate the faulty node, use this mode.
  • Continual measurement: To detect network performance degradation in a timely manner, use this mode. This mode displays continual running status of each network node.

The packet loss and delay statistics obtained from iPCA hop-by-hop measurement are the basis for network operation and maintenance. You can diagnose network faults based on the statistics and adjust services in real time, to ensure network reliability and improve network use experience.

Prerequisites

Before configuring iPCA hop-by-hop performance measurement, complete the following tasks:
  • Configuring static routes or routing protocols to ensure network connectivity between devices
  • Configuring the Network Time Protocol (NTP) or 1588v2 to synchronize all clocks on networks
    • Most switches support the NTP protocol. An iPCA measurement interval is usually several seconds. The precision of NTP, 50 ms, can ensure the accuracy of measurement result. For details about NTP, see NTP Configuration.

    • 1588v2 is a precise network clock synchronization protocol. It implements submicrosecond-level time synchronization, but has a high cost. For details about 1588v2, see 1588v2 (PTP) Configuration.

    NOTE:
    • If 1588v2 has been deployed on a network, it is the best choice for periodic time synchronization in iPCA.

    • To implement unidirectional delay measurement, configure the precise time synchronization protocol, 1588v2.

Data Plan

Before configuring iPCA hop-by-hop performance measurement, prepare the data in Table 15-7.
Table 15-7 Data preparation

No.

Data

1

MCP ID, (optional) UDP port number, (optional) authentication mode and password, measurement instance, (optional) instance description, ACH ID, DCP ID included in the measurement instance

2

DCP ID, (optional) color bit for packet loss measurement, (optional) color bit for delay measurement, (optional) measurement interval, target flow characteristics, target flow direction, TLP ID and role, measurement duration

Configuration Process

Configuring the MCP and Configuring the DCP can be performed in any sequence. The parameter settings on MCP and DCPs must be the same.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 30449

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next