No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Layer 2 NetStream Flow Configuration

Verifying the Layer 2 NetStream Flow Configuration

Context

You can run commands to verify that Layer 2 NetStream flow statistics export has been configured correctly.

Procedure

  • Run the display forward enp [ slot slot-id ] command to check whether the card performs NetStream sampling in enhanced mode.

    NOTE:

    The CE12800E configured with ED-E, EG-E, and EGA-E series cards does not support this command.

  • Run the display netstream cache ethernet [ { inbound | outbound } | destination interface interface-type interface-number | destination mac-address mac-address | source interface interface-type interface-number | source mac-address mac-address | ethernet-type ethernet-type | vlan vlan-id ] * slot slot-id [ chip chip-id ] [ verbose ] command to check detailed statistics about Layer 2 NetStream flows on the card.
  • Run the display netstream export ethernet template command to check the exported template information.
  • Run the display netstream statistics ethernet slot slot-id [ chip chip-id ] command to check Layer 2 NetStream flow statistics on the card.
  • Run the display netstream { all | global | interface interface-type interface-number } command to check the NetStream configuration.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 20846

Downloads: 22

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next