No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Flow Sampling Resources

Configuring Flow Sampling Resources

Context

A device can use mirroring resources or snoop resources for flow sampling. If the device uses mirroring resources for flow sampling, flow sampling and port mirroring cannot be configured simultaneously on the same interface. If the device uses snoop resources for flow sampling, port mirroring and inbound flow sampling can be configured simultaneously on the same interface. In this case, you can also configure inbound port mirroring and outbound flow sampling simultaneously on the same interface.

NOTE:

The CE12800E does not support flow sampling resource configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run sflow sampling [ rate rate ] inbound resource snoop

    Inbound flow sampling is configured to use snoop resource.

    By default, inbound flow sampling uses mirroring resources.

    If you run this command in the system view to configure inbound Flow sampling to use snoop resources, and run the sflow sampling rate rate inbound command in the interface view to configure inbound flow sampling, the flow sampling rate of snoop resources is configured as the inbound flow sampling rate on the interface.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 29383

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next