No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, sFlow, and NETCONF.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for Telemetry

Licensing Requirements and Limitations for Telemetry

Involved Network Elements

The switch needs to be used with a collector.

Licensing Requirements

The telemetry function is controlled by a license. By default, this function is disabled on a new device. To use the telemetry function, apply for and purchase the license from the device vendor.

In V200R003C00, you need to load a license and restart the device before you can configure the telemetry function. In V200R005C00 and later versions, you can load a license and then configure the telemetry function without restarting the device.

Version Requirements

Table 17-7 Products and minimum version supporting Telemetry


Minimum Version Required

CE12804/CE12808/CE12812 V200R003C00
CE12816 V200R003C00
CE12804S/CE12808S V200R003C00
CE12800E V200R003C00

Feature Limitations

  • The switch supports Telemetry for only physical interfaces and their queues.
  • The switch can send monitoring data to the target collector with the IPv4 address only.
  • In versions earlier than V200R005C00, only the Admin-VS supports Telemetry.

    Starting from V200R005C00, in port mode, only the Admin-VS supports Telemetry; in group mode, all VSs support Telemetry.

Updated: 2019-04-20

Document ID: EDOC1100075344

Views: 28445

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next