Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Attack Source Tracing Does Not Take Effect
Fault Description
Attack source tracing does not take effect after attack source tracing is configured.
Common Causes
Possible causes are as follows:
- The attack defense policy is not applied to any object.
- The checking threshold for attack source tracing is large.
Procedure
- Determine whether the attack defense policy configured with attack source tracing is applied.
- Run the display current-configuration command in the system view to check whether the cpu-defend-policy command has been configured.
- If the policy is not configured, run the cpu-defend-policy command in the system view to configure the policy. If the policy is configured, go to the next step.
- Check whether the checking threshold for attack source tracing is large.
Run the display this command in the attack defense policy view to check the checking threshold for attack source tracing. If the value is large, run the auto-defend threshold command in the attack defense policy view to reduce the value.