Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the ACL Configuration
Procedure
- Run the display acl { acl-number | name acl-name | all } command to view the configuration about a specific ACL or all ACLs.
- Run the display time-range { all | time-name } command to view information about the time range.
- Run the display acl hardware statistics [ acl-number | name acl-name ] command to view statistics about packets matching a hardware ACL.
- The switch can display only the statistics about the packets matching hardware ACLs referenced by the MQC and ACL-based traffic policy. In addition, you need to run the statistics enable command to enable traffic statistics collection and run the traffic-statistics, traffic-statistics, traffic-statistics, or traffic-statistics command to enable traffic statistics collection for a simplified traffic policy.
- The protocol packets, such as FTP, TFTP, Telnet, SNMP, HTTP, routing, and multicast packets, are sent to the CPU and matched against software ACLs. To view the number of times packets match software ACL rules, run the display acl command.
