No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Inter-AS VPN Option C Configuration

Verifying the Inter-AS VPN Option C Configuration


The inter-AS VPN Option C configuration is complete.


  • Run the display bgp vpnv4 all peer command on the PE device. If the status of the EBGP peer between PEs is Established, the configuration is successful.
  • Run the display bgp vpnv4 all routing-table command on the PE or ASBR. If the PE has VPN IPv4 routes and the ASBR has no VPN IPv4 route, the configuration is successful.
  • Run the display bgp routing-table label command to check information about the label of the IPv4 route on the ASBR.
  • Run the display ip routing-table vpn-instance vpn-instance-name command to check the VPN routing table on the PE device. The command displays all VPN routes to all the CE devices in the VPN routing table of the PE device.
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14095

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next