No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting Statistics on Traffic on a VPLS PW

Collecting Statistics on Traffic on a VPLS PW


To analyze the network traffic model, collect statistics on traffic of the specified PW.

Perform the following steps on the device configured with the VSI:


When a VSI consists of multiple PW links, the device collects the total sum of traffic on multiple PW links.


  1. Run the system-view command to enter the system view.
  2. Run the vsi vsi-name [ static ] [ bd-mode ] command to enter the VSI view.
  3. Run the pwsignal ldp command to configure LDP as the PW signaling protocol and enter the VSI-LDP view.
  4. Run the traffic-statistics peer peer-address [ negotiation-vc-id vc-id ] { enable | disable } command to configure the traffic statistics function on a Martini VPLS PW.

  5. Run the commit command to commit the configuration.
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14195

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next