No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of VPLS Configuration Tasks

Summary of VPLS Configuration Tasks

After you configure basic VPLS functions, a VPLS network can be established. You can perform other configurations according to your needs. In addition to VPLS in Martini mode, the configurations include tunnel policies, HVPLS, and VPLS QoS.

Table 6-7 lists VPLS configuration tasks.

Table 6-7 VPLS configuration tasks

Scenario

Description

Task

Configure VPLS in Martini mode.

A VPLS network can be established only after VPLS in Martini mode is configured.

Configuring LDP VPLS

Configure and apply a tunnel policy.

When VPN services need to be transmitted over tunnels or when multiple tunnels need to perform load balancing to fully use network resources, configure and apply a tunnel policy on the PE.

Configuring and Applying a Tunnel Policy

Configure LDP HVPLS.

When there are a large number of PEs on the VPLS network, configure LDP HVPLS to construct a hierarchical network structure, reducing performance requirements on the PEs.

Configuring LDP HVPLS

Configure VPLS parameters.

You can configure or modify VSI parameters on an MPLS L2VPN network.

Setting Related Parameters for a VSI

Configure MPLS L2VPN QoS.

On an MPLS L2VPN network, you can configure the DiffServ mode to differentiate services in a VPN and schedule service packets in queues based on the packet priorities.

Configuring MPLS L2VPN QoS

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14488

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next