No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection to Optimize the VPN Access Layer

Configuring Route Reflection to Optimize the VPN Access Layer

Pre-configuration Tasks

If a PE and the connected CEs are in the same AS, you can deploy a BGP RR to reduce the number of IBGP connections between CEs and facilitate maintenance and management.

Before configuring route reflection to optimize the VPN access layer, complete the following task:

  • Configure the routing protocol for the MPLS backbone network to implement IP interworking between devices on the backbone network.

Configuration Procedure

All the following configuration tasks are mandatory. The RR is a PE device.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 16465

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next