No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Basic BGP/MPLS IP VPN Functions

Verifying the Configuration of Basic BGP/MPLS IP VPN Functions

Prerequisites

All configurations about basic BGP/MPLS IP VPN functions are complete.

Procedure

  • Run the following commands on the PE device to check information about the created VPN instance IPv4 address family, including the RD and other attributes.

    • Run the display ip vpn-instance vpn-instance-name command to check brief information about a specified VPN instance.
    • Run the display ip vpn-instance verbose vpn-instance-name command to check detailed information about a specified VPN instance.
    • Run the display ip vpn-instance import-vt ivt-value command to check information about the VPN instance with the specified import VPN target.
    • Run the display ip vpn-instance [ vpn-instance-name ] interface command to view information about the interface bound to a specified VPN instance.

    • Run the display mpls label-stack vpn-instance vpn-instance-name ip-address command to check L3VPN label stack information.

  • Run the following commands on the PE and CE devices to check information about the IPv4 VPN routes to the local and remote sites.

    • Run the display ip routing-table vpn-instance vpn-instance-name command on the PE device to check the routing information of a specified VPN instance IPv4 address family.

    • Run the display ip routing-table command on the CE device to check routing information.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14389

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next