No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying a Tunnel Selector

Applying a Tunnel Selector

Context

The system can use a tunnel selector to have routes iterated to a proper tunnel only after the tunnel selector is applied to the routes on the PE or ASBR.

Perform the following steps on the PE or ASBR where a tunnel selector needs to be applied:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp as-number

    The BGP view is displayed.

    By default, BGP is disabled.

  3. Run ipv4-family vpnv4

    The BGP-VPNv4 address family view is displayed.

    By default, the BGP-VPNv4 address family view is disabled.

  4. Run tunnel-selector tunnel-selector-name

    A tunnel selector is applied to VPNv4 routes on the local device.

    By default, a tunnel selector is not applied.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14441

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next