No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VPN Dual-Stack Access

VPN Dual-Stack Access

Due to the shortage of IPv4 addresses, many carriers have started to deploy IPv6 networks. To facilitate the transition from IPv4 to IPv6 for existing BGP/MPLS IPv4 VPN services, carriers can use VPN dual-stack access.

VPN dual-stack allows a VPN to use both IPv4 and IPv6 address families. With this function, VPN interfaces that would otherwise support only a single type of protocol stack can support both IPv4 and IPv6 VPN access.

As shown in Figure 2-31, IPv4/IPv6 VPN dual-stack access allows VPN sites to support both IPv4 and IPv6 networks. In addition, IPv4 and IPv6 services are transmitted to a PE device through the same interface.

Figure 2-31 VPN dual-stack access

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14300

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next