No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 Route Import Between Instances

Configuring IPv6 Route Import Between Instances

Usage Scenario

In BGP/MPLS IPv6 VPN networking, IPv6 users of two VPNs with matching VPN targets can communicate with each other. However, IPv6 VPN users cannot communicate with IPv6 public network users or IPv6 VPN users without matching VPN targets. To enable these users to communicate with each other, configure IPv6 route import between different instances.

IPv6 route import between instances is classified into the following types:
  • IPv6 route import between VPN and public network instances

  • IPv6 route import between VPN instances

IPv6 routes are first imported to the routing table of the specified protocol. For example, OSPFv3 routes are first imported to the OSPFv3 routing table of a public network instance. If the imported routes are preferred in the OSPFv3 routing table, they will be further imported to the IPv6 routing table of a VPN or public network instance to guide traffic forwarding. In addition, these routes will be advertised to other devices on the network.

Currently, the following types of IPv6 routes can be imported between instances:
  • Direct routes

  • Static routes

  • OSPFv3 routes

  • IS-IS routes

  • BGP4+ routes

Pre-configuration Tasks

Before configuring IPv6 route import between instances, complete the following task:

Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14295

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next