No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of PWE3 Configuration Tasks

Summary of PWE3 Configuration Tasks

The device supports dynamic PW. If a network spans multiple autonomous systems (ASs), you need to configure inter-AS PWE3.

Table 5-1 PWE3 configuration tasks




Configure PWE3

Configuring dynamic PW: applies to large-scale enterprises or local area networks (LANs) of small-scale carriers.

Configuring a Dynamic PW

Configure inter-AS PWE3

Configure inter-AS PWE3 if the PWE3 backbone network spans multiple ASs.

Configuring Inter-AS PWE3

Configure and apply a tunnel policy

This task is required when PWE3 services need to be transmitted over TE tunnels or when multiple tunnels need to perform load balancing to fully use network resources.

Configuring and Applying a Tunnel Policy

Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14346

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next