No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-IBGP Between the Hub-PE and Spoke-PE

Configuring MP-IBGP Between the Hub-PE and Spoke-PE

Context

The Hub-PE device must set up MP-IBGP peer relationships with all the Spoke-PE devices. Spoke-PE devices do not need to set up MP-IBGP peer relationships between each other.

Perform the following steps on the Hub-PE and Spoke-PE devices.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number-plain

    The remote PE is configured as a BGP peer.

  4. Run peer ipv4-address connect-interface loopback interface-number

    An interface is specified for setting up a Transmission Control Protocol (TCP) connection with the BGP peer.

    NOTE:

    A local PE device must use a loopback interface address with a 32-bit mask to set up an MP-IBGP peer relationship with the remote PE device. This ensures that VPN routes can be iterated to tunnels. The route to the local loopback interface is advertised to the remote PE using an IGP on the MPLS backbone network.

  5. Run ipv4-family vpnv4 [ unicast ]

    The BGP-VPNv4 address family view is displayed.

  6. Run peer ipv4-address enable

    The ability to exchange VPN IPv4 routes with the BGP peer is enabled.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14347

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next