No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IPv6 MCE

Configuring an IPv6 MCE

You can configure a multi-instance routing protocol on an MCE device to isolate services of different VPN users on a LAN.

Pre-configuration Tasks

Before configuring an IPv6 MCE, complete the following tasks:

  • Configure VPN instances on PEs on the multi-instance CE, and the PE that is accessed by it (each service with a VPN instance). For details, see Configuring VPN instances on PEs.

    NOTE:

    When VPN sites connected to the MCE device need to communicate with one another, configure VPN targets on the MCE device to implement VPN route cross. If the VPN sites connected to the MCE device do not need to communicate with one another, you do not need to configure VPN targets.

  • Configure the link layer protocol and network layer protocol for LAN interfaces and connect the LAN to the MCE device (each service using an interface to access the MCE device).

  • Bind VPN instances to the interfaces of the MCE device and attached PE devices and configure IP addresses for these interfaces.

Configuration Procedure

All the following tasks are mandatory. Perform these tasks in sequence to complete the IPv6 MCE configuration.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14447

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next