No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VSI to Ignore the AC Status

Configuring a VSI to Ignore the AC Status

Context

Figure 6-15 Networking diagram of configuring a VSI to ignore the AC status

As shown in Figure 6-15, devices A, B, C, and D are on the old network, while devices A', B', C', and D' are on the new network, if the services running on the old network will switch to the new network, and you want to check whether the VSI on the new network can work normally before the service switchover, you need to configure the VSI to ignore the AC status on D'. After the configuration, the VSI on D' keeps Up before the DSLAM is connected to the new network.

If an AC interface is Down and the PW is Up, the VSI remains Up after being enabled to ignore AC status. If an AC interface is Up and the PW is Down, the VSI remains Up after being enabled to ignore AC status.

Do as follows on the PE (D' in Figure 6-15):

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run the following commands as required:
    • If you want to prevent the status of all the VSIs from being affected by the status of the AC:

      1. Run mpls l2vpn

        The MPLS L2VPN view is display.

      2. Run vpls ignore-ac-state

        The status of a VSI is prevented from being affected by the status of the AC.

    • If you want to prevent the status of one VSI from being affected by the status of the AC:

      1. Run vsi vsi-name [ static ] [ bd-mode ]

        The VSI view is displayed.

      2. Run ignore-ac-state

        The status of a VSI is prevented from being affected by the status of the AC.

  3. Run commit

    The configuration is committed.

Follow-up Procedure

The vpls ignore-ac-state or ignore-ac-state are used only before the service switchover between a new VPLS network and an old one. After the service switchover, run the undo vpls ignore-ac-state or undo ignore-ac-state command to restore the default setting.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14477

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next