No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Tunnel Selector

Configuring a Tunnel Selector


Perform the following steps on the PE or ASBR where a tunnel policy needs to be applied.


  1. Run system-view

    The system view is displayed.

  2. Run tunnel-selector tunnel-selector-name { permit | deny } node node

    A tunnel selector is created, and the view of the tunnel selector is displayed.

    By default, a tunnel selector is not created.

  3. Run apply tunnel-policy tunnel-policy-name

    A tunnel policy is applied to the routes.

    By default, the tunnel policy is not applied.

  4. Run commit

    The configuration is committed.

Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14587

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next