No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

CloudEngine 12800 and 12800E V200R005C10

This document describes the configurations of VPN, including GRE, BGP/MPLS IP VPN, BGP/MPLS IPv6 VPN, VLL, PWE3, and VPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Hub and Spoke

Configuring the Hub and Spoke

In Hub and Spoke networking, a central site (called the Hub site) is deployed and all the other sites (called Spoke sites) communicate through the Hub site. The Hub site controls communication between Spoke sites.

Pre-configuration Tasks

Before configuring the Hub and Spoke, complete the following tasks:

  • Configure IGP on the PE and P devices on the MPLS backbone network.

    NOTE:

    RIP-1 cannot be used on the backbone network.

  • Configure basic MPLS capabilities and MPLS LDP on the PE and P devices on the MPLS backbone network.

  • On the CE device, configure the IP addresses for connecting to the PE device.

Configuration Procedure

All the following tasks are mandatory. Perform these tasks in sequence to complete the Hub and Spoke configuration.

Translation
Download
Updated: 2019-04-03

Document ID: EDOC1100075353

Views: 14286

Downloads: 25

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next