Enabling RIPng on Interfaces
Context
After RIPng is enabled on an interface, devices can exchange RIPng routing information through this interface.
Procedure
- Run system-view
The system view is displayed.
- Run interface interface-type interface-number
The interface view is displayed.
- On an Ethernet interface, run undo portswitch
The interface is switched to Layer 3 mode.
By default, an Ethernet interface works in Layer 2 mode.
The mode switching function takes effect when the interface only has attribute configurations (for example, shutdown and description configurations). Alternatively, if configuration information supported by both Layer 2 and Layer 3 interfaces exists (for example, mode lacp and lacp system-id configurations), no configuration that is not supported after the working mode of the interface is switched can exist. If unsupported configurations exist on the interface, delete the configurations first and then run the undo portswitch command.
If many Ethernet interfaces need to be switched to Layer 3 mode, run the undo portswitch batch interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command in the system view to switch these interfaces to Layer 3 mode in batches.
- Run ripng process-id enable
RIPng is enabled on the specified interface.
If IPv6 is not enabled in the interface, this command cannot be run.
If RIPng needs to be enabled on multiple interfaces of a switch, repeat steps 2 and 3.
- Run commit
The configuration is committed.
