No relevant resource is found in the selected language.
Enterprise
Worldwide
Search
Support Documentation
CloudEngine 12800 and 12800E V200R005C10 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 Static Routes

Configuring IPv6 Static Routes

Pre-configuration Tasks

Before configuring IPv6 static routes, complete the following task:

  • Configure link layer parameters and IPv6 addresses for interfaces to ensure network-layer communication between neighbor nodes.

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the IPv6 Static Route Configuration) in any sequence as required.

Translation
简体中文
Download
Updated: 2021-09-17

Document ID: EDOC1100075354

Views: 419668

Downloads: 114

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Digital Signature File

Digital Signature Authentication Mode
Share
Previous Next

Copyright © 2023 Huawei Technologies Co., Ltd. All rights reserved.

You are going to visit :