Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic IPv6 BFD for IS-IS
Applicable Environment
If the requirement for data transmission is high and IS-IS convergence needs to be accelerated when the link status changes, you can configure dynamic BFD on IS-IS links. BFD can provide link failure detection featuring light load and high speed (at the millisecond level). With dynamic BFD, routing protocols can dynamically trigger the establishment of BFD sessions.
Dynamic BFD needs to be configured based on the actual network environment. If the time parameters are set improperly, network flapping may occur.
