No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for MSDP

Default Settings for MSDP

Table 6-5 lists the default settings for MSDP.

Table 6-5 Default settings for MSDP
Parameter Default Setting
MSDP Disabled
MSDP peer Unspecified
MSDP authentication Unspecified
SA cache Enabled after an MSDP peer relationship is established
Content of SA messages (S, G) information without encapsulated multicast packets
Rule for filtering SA messages Unspecified. No SA message is filtered out.
Source RP address in the SA message Actual RP address used to create an SA message
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 30161

Downloads: 34

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next