No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Sending IGMP Query Messages upon Topology Changes

Sending IGMP Query Messages upon Topology Changes

Context

Changes of the Layer 2 network topology may trigger changes of the multicast forwarding paths. When a link fails, the switch sends IGMP Query messages and the group members reply with IGMP Report messages. The switch then updates information about multicast member ports based on the IGMP Report messages. In this manner, multicast packets can be switched to new forwarding paths quickly.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run igmp snooping send-query enable

    IGMP Query messages are sent upon topology changes.

    By default, the switch is disabled from sending IGMP Query messages upon topology changes.

    This command enables the switch to send IGMP Query messages (the source IP address is 192.168.0.1 by default) upon topology changes, and update information about multicast member ports quickly, so that multicast packets to the downstream members are interrupted only for a short period.

  3. (Optional) Run igmp snooping send-query source-address ip-address

    The source IP address of an IGMP General Query message is configured.

    By default, the source IP address of an IGMP General Query message sent upon topology changes is 192.168.0.1. If this IP address is used by another device on the network, use this command to set another IP address.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 24818

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next