No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an SSM Group Policy

(Optional) Configuring an SSM Group Policy

Context

If the address of the multicast group that a user joins is not within an SSM group address range, you need to configure an SSM group policy in the VLAN to add the multicast group address to the SSM group address range. Then the user can obtain SSM services. An SSM group policy needs to reference an ACL6. For details about ACL6 configuration, see "ACL Configuration" in the CloudEngine 8800, 7800, 6800, and 5800 Series Switches Configuration Guide - Security.

NOTE:

When an ACL6 to be referenced by an SSM group policy is configured, deny in the ACL6 is valid for all multicast groups by default. To exclude a multicast group address from an SSM group address range, you also need to run the rule permit source any command.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run mld snooping ssm-policy { basic-acl6-number | acl6-name acl6-name }

    An SSM group policy is configured.

    By default, the SSM group address range is FF3x::/32. The value of x cannot be 1 or 2.

    After you configure an SSM group policy, all the multicast groups permitted by this policy are SSM groups.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 20880

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next