No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Maximum Number of Invalid Layer 2 Multicast Protocol Packets Allowed on the Multicast Device

Configuring the Maximum Number of Invalid Layer 2 Multicast Protocol Packets Allowed on the Multicast Device

Context

When forwarding entries cannot be created on a multicast network, configure the maximum number of invalid Layer 2 multicast protocol packets allowed on the multicast device. Then, you can locate and rectify the fault based on statistics and detailed information about invalid Layer 2 multicast protocol packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast layer-2 invalid-packet mld snooping max-count max-number

    The maximum number of invalid Layer 2 multicast protocol packets allowed on the multicast device is specified.

    By default, a multicast device can store a maximum of 10 invalid Layer 2 multicast protocol packets.

  3. Run commit

    The configuration is committed.

Verifying the Configuration

  • Run the display current-configuration | include multicast layer-2 invalid-packet mld snooping command to check the maximum number of invalid Layer 2 multicast protocol packets allowed on the multicast device.

  • Run the display mld snooping invalid-packet vlan [ vlan-id ] [ message-type { done | query | report | hello } ] command to check statistics about invalid Layer 2 multicast protocol packets stored on the multicast device.

  • Run the display mld snooping invalid-packet [ packet-number ] verbose command to check detailed information about invalid Layer 2 multicast protocol packets stored on the multicast device.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 22747

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next