No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Filtering Multicast Data on an Interface

Filtering Multicast Data on an Interface

Context

To reject certain types of multicast data, you can configure the switch to filter multicast data packets from a certain VLAN on an interface.

NOTE:

The CE6870EI and CE6875EI do not support this function.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run multicast deny-vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    The multicast data from specified VLANs is filtered out.

    NOTE:

    You must specify a VLAN to which the interface has already been added. Otherwise, the configuration does not take effect.

    This command can discard only multicast data packets that meet both of the following conditions:
    • The destination MAC address is an IP multicast MAC address (IPv4 MAC address starting with 0x01005E).
    • The packet encapsulation protocol is UDP.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 22713

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next