No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, PIM (IPv4), PIM (IPv6), MSDP, multicast VPN, multicast route management (IPv4), multicast route management (IPv6), IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic IGMP Snooping Function Configuration

Verifying the Basic IGMP Snooping Function Configuration

Context

After the configurations are complete, run the following commands in any view to check IGMP spooning configurations and the forwarding entries.

Procedure

  • Run the display igmp snooping [ vlan [ vlan-id ] ] configuration command to check the IGMP snooping configuration in a VLAN.
  • Run the display igmp snooping [ vlan [ vlan-id ] ] command to check all the IGMP snooping running parameters in a VLAN.
  • Run the display igmp snooping port-info [ vlan vlan-id [ group-address group-address ] ] [ verbose ] command to check member ports of the multicast group.
  • Run the display igmp snooping router-port [ vlan vlan-id ] command to check router ports.
  • Run the display multicast layer-2 ip fib [ vlan vlan-id [ [ source source-address ] group group-address] ] command to check the multicast forwarding table in a VLAN.
  • Run the display multicast layer-2 forwarding-mode vlan [ vlan-id ] command to check multicast data forwarding mode in the VLAN.
  • Run the display igmp snooping querier vlan [ vlan-id ] command to check the IGMP snooping querier configuration.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075361

Views: 20828

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next