No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling 1588v2 Globally

Enabling 1588v2 Globally

Context

In a PTP domain, a 1588v2 node functioning as an OC can synchronize the time with an upstream device or synchronize the time to a downstream device. In the system view, in addition to enabling 1588v2, you need to configure required basic information such as domain and virtual clock ID to build a 1588v2 clock synchronization network.

Perform the following steps on each 1588v2 device.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ptp enable

    1588v2 is enabled.

    By default, 1588v2 is disabled on a switch.

  3. Run ptp device-type oc

    The 1588v2 clock mode is set to OC.

    By default, no 1588v2 clock mode is configured for a switch.

  4. (Optional) Run ptp slaveonly

    The OC is configured to work in slave-only mode.

    By default, an OC does not work in slave-only mode. That is, an OC can function as a master or slave clock.

  5. (Optional) Run ptp domain domain-value

    A clock domain ID is specified.

    By default, a 1588v2 device belongs to domain 0.

    NOTE:

    Devices in the same clock domain can exchange 1588v2 messages to synchronize the time.

  6. (Optional) Run ptp virtual-clock-id clock-id-value

    A virtual clock ID is set.

    By default, a 1588v2 device has only the default clock ID and does not have a virtual clock ID. The default clock ID is generated by padding fffe in the middle of the system MAC address. For example, if the system MAC address is 111122223333, the default clock ID is 111122fffe223333.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100075362

Views: 25794

Downloads: 102

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next