No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

CloudEngine 8800, 7800, 6800, and 5800 V200R005C10

This document describes the configurations of Device Management, including device status query, hardware management, Information Center Configuration, NTP, Synchronous Ethernet Configuration, Fault Management Configuration, Energy-Saving Management Configuration, Performance Management Configuration, Maintenance Assistant Configuration, and OPS Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Dynamic/Static 1588v2 Configuration

Verifying the Dynamic/Static 1588v2 Configuration


After configuring 1588v2, you can check whether the 1588v2 configuration meets requirements.


  • Run the display ptp all [ state | config ] command to check the 1588v2 operating status and configurations.
  • Run the display ptp interface interface-type interface-number command to check 1588v2 information on a specified 1588v2 interface.
  • Run the display ptp utc command to check the UTC time.
Updated: 2019-04-20

Document ID: EDOC1100075362

Views: 29328

Downloads: 107

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next